Filter
Top Products
Programming
After the Digital Temperature Control has been properly installed and wired, it is ready to be programmed for either the
standard on/off cycling gas solenoid/electric heating system, or the modulating gas valve system. Then, as requested by
the customer, the controller can be set for set lock configuration, F or C operation, and the display type. This function is
to be done by the authorized technician. See Figure14 Service Instructions for details. NOTE: The temperature con-
troller is pre-programmed for On/Off operation, open set lock, and set point display.
Once the Digital Temperature Control has been service programmed, it then can be operator programmed for set point.
See Figure 15 Operator Instructions for details.
Be sure to thoroughly go over the Operator Instructions with the customer to be sure they are familiar with the new con-
trol. Leave the spare copy of the Operator Instructions, PN 36940, with the customer for their future reference.
A copy is enclosed with the new temperature control.
8
Figure 13
Figure 11 - Wiring Diagram Showing Electrical Connections
(Refer to Table 2)
Figure 12 - Wiring Diagram Showing Electrical Connections
(Refer to Table 2)
Purple
Purple/White