24 25
24 25
Using the vacuum cleaner
1. Make sure the hand-held vacuum cleaner
hasbeencorrectlyttedtotheappliance.
2. Attachtheoornozzle(21)byinserting
the connector (19) into the terminal at the
point of the appliance and screwing the
mounting screw (20) into the connector on
theoornozzle.
3. Turn on the appliance by pushing the
on/off button (2) on the foldable handle (1)
forward. The appliance has two setting:
o “FLOOR” is for cleaning hard surfaces
(stoneoors,woodenoorsetc.).
o “CARPET” is for cleaning carpets and
rugs(thebrush(22)insidetheoor
nozzle rotates).
4. Push the on/off button backward to the
“OFF” position to swith off the appliance.
Using the hand-held vacuum cleaner
1. Detach the hand-held vacuum cleaner
from the appliance by pressing the release
button (4) whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
2. Push the on/off button (6) forward to switch
on the appliance and backward to switch it
off.
3. The crevice nozzle
(13)isttedtothe
hand-held vacuum
cleaner and can
be extended from
the nozzle tip (12)
when cleaning
difculttoreach
spots (see illustration).
4. Attach the hand-held vacuum into the
hollow on the appliance until you hear a
click,onceyouhavenishedusingit.
NOTE:
• If the appliance loses suction power during
use, the battery may need to be recharged.
• Lack of suction power may also be caused
bythelterbeingblockedandneeding
cleaning (see “Cleaning of dust container
andemptyingoflter”).
• If the appliance still does not have full
suction power after cleaning or replacing
thelter,thenozzletiporthenozzlemay
be blocked.
• NOTE: Check cause of fault and correct.
Do not use the appliance if any air holes
are blocked. Permanent motor damage
can result.
• We recommend that you empty the dust
container after each vacuuming (see
“Emptying of dust container and cleaning
oflter”below).
Tips!
To save room
during storage,
the handle of the
appliance may
be folded. Press
down the release
button for the foldable handle (3) and tilt the
handle toward the appliance (see illustration).
DUST CONTAINER AND FILTER
This appliance is not equipped with a dust
bag. The dust/dirt is sucked up into the
transparent dust holder instead. Once the
dust is in this container, it whirls around so
that it does not block suction. The air sucked
in is cleaned by means of a two-component
washablepermanentlterinthedust
container.
Emptying of dust container and cleaning of
lter
IMPORTANT! If the appliance loses suction
powerduringuse,thelterpadmaybedirty,
and needs cleaning or replacing. Never use the
appliance,whenthelterisdirtyorwhenithas
notbeentted.
1. Detach the hand-held vacuum cleaner
from the appliance by pressing the release
button whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
2. Grab the dust container with one hand and
press the opening button (7) to release the
dust container from the motor section (14)
(see illustration).
3. Pullthetwopartsofthelteroutofthe
dust container and empty the container.
If necessary,
rinse the dust
container with
clean water
and wipe the
container with a
dry cloth.