Filter
Top Products
12
Top Innovations, Inc.
TROUBLESHOOTING
PROBLEM
Unit fails to steam. Lighted
On/Off Switch does not
illuminate.
Unit is not plugged in.
Plug into electrical outlet.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Reset Circuit Breaker / Ground
Fault Interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Unit fails to steam. Lighted
On/Off Switch does illuminate.
W
ater Reservoir is empty. Refill Water Reservoir using
procedures on page 9 of this
manual.
Mineral build-up in unit.
Follow Removing Mineral
Build-Up procedure on page 11
of this manual.
Steam output is intermittent.
Mineral build-up in unit.
It is normal for unit to
periodically stop steaming for a
few seconds. If steam stays of
f
for longer periods, follow
Removing Mineral Build-Up
procedure on page 11 of this
manual.
Unit is emitting excess water. Water condensation in Steam
Hose.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button.
Continue until excess water is
released.
POSSIBLE CAUSE SOLUTION
Water Reservoir has been
over-filled.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button to
remove water that may have
condensed in Steam Hose.
Empty some water out of Water
Reservoir.
Unit has not reached operating
temperature.
Wait until Steam Ready Light
deactivates to steam.