Filter
Top Products
5A. INTRODUCTION
The Roth Radiant Panel System
®
was developed for the wood frame
houses of the North American and Scandinavian markets. It was
designed for easy installation over any new or existing sub-floor,
wood or concrete, and for use with many different floor coverings,
such as carpet, tile or hardwood. This is done without the structural
changes needed to accommodate the additional load of lightweight
concrete and with minimal effects to the finished floor height. It is
ideal for retrofit systems, but it’s also great for new construction when
you don’t want the weight, expense or water problems of lightweight
concrete. The efficient design of the system, heavy gauge, full-face
aluminum sheet on top and EPS insulating foam on the bottom,
focuses the heat exactly where you want it – directly under the
finished floor – so that the system can run at the lowest temperature
possible. The quick recovery time makes this system one of the few
times that temperature setback makes sense in radiant floor heating.
These are just some of the advantages you will receive from the
intelligent design and high quality of the Roth Radiant Panel System
®
.