Filter
Top Products
IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.
First Supervisor to Arrive Function 31
Page 20
Valid User Code
Level: Grand Master
This function will override the set schedule, denying USERS access until a user with a MINIMUM ACCESS
OF SUPERVISOR (02-04) enters their code. After a supervisor enters their code, the schedule will resume
from that point.
To DISABLE the first supervisor function, enter "0".
To ENABLE the first supervisor function, enter "1".
ENTRIES VISUAL / AUDIO
Note
The DEFAULT for this function is “0” DISABLED.
At 0000 HOURS this function RESETS.
ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.
Select One:
(0) DISABLE
(1) ENABLE
0
*
1
*
Function Number
13
*
#
See Note
Exit
*
1.
2.
3.
4.
Function 32 Pin Only Entry
Page 21
IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.
Valid User Code
Level: Grand Master
Function allows a SHORTER LENGTH OF CODE to be entered by the user to gain access.
When ENABLED, user enters their PIN number FOLLOWED BY “
*
”.
The POSSIBLE PROBLEMS this function poses are:
• SECURITY of the lock is COMPROMISED by fewer possible entries;
• Possibility of DUPLICATE PIN NUMBERS;
• AUDIT TRAIL is NOT RELIABLE with this function due to restricted retrieval information.
To ENABLE the PIN ONLY, enter "0".
To ENABLE the UID & PIN, enter "1".
ENTRIES VISUAL / AUDIO
Note
The DEFAULT for this function is “1” (UID and PIN REQUIRED for entry).
User MUST enter PIN NUMBER and “
*
” to gain access.
ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.
Function Number
23
*
#
See Note
Exit
*
Select One:
(0) PIN ONLY
(1) UID & PIN
0
*
1
*
1.
2.
3.
4.