Filter
Top Products
RP835 & PK836 4
Connect the Programming Keypad (PK836) to the Programming Keypad
(PK836) connector.
Note: The Programming Keypad (PK836) is not able to operate on battery
power only.
8. Test the repeater from the required mounting location before permanently
mounting the unit.
9. Mount the base to the wall using four screws and replace the front cover.
When the tamper switch is open, the bi-
color LED provides indication regarding
repeater transmission and reception as
an aid during the installation procedure
– see Table 1. When the tamper switch
is closed, the bi-color LED provides
indication regarding power status – see
Table 2.
REGISTERING THE REPEATER TO
THE CONTROL PANEL
For the control panel to recognize the repeater, you
must register the repeater to the control panel.
To register the repeater to the control panel:
1. Set the control panel to Registration mode
as follows:
• From the Programming menu, select
Devices, Repeaters [914].
• Select the repeater you want to register
(1-4).
• From the repeater’s sub-menu, select
Register [#1].
2. Send two Status transmissions from the
repeater as follows:
• On the Programming Keypad (PK836),
press until 5. STS Transmit appears on
the display.
• Press 9.
• Press 9 again.
LED Indication Description
Flashing Green Signal Reception
Flashing Red Signal Transmission
Table 1: LED Indication (Tamper Open)
LED Indication Description
Steady Green AC & Battery OK
Flashing Red AC Loss
Flashing Orange Low Battery
Table 2: LED Indication (Tamper Closed)
Figure 3: LCD rogramming
Keypad (PK836)