Filter
Top Products
12
Vermont Castings Radiance Vent-Free Gas Heater
20004555
MOTOR
SNAPSTAT
ON/OFF
RHEOSTAT
WHT
WHT
BLK
BLK
BLK
GRN
BLK
POWER
Fig. 15 #2767 / FK26 Fan Wiring Diagram
Disconnect power
before servicing.
ST196
The optional fan kit is equipped with a three-
prong (grounding) plug for your protection against
shock hazard and should be plugged directly into
a properly grounded three-prong outlet. Do not
cut or remove the grounding prong from this
plug.
WARNING
NOTE: If you are installing the fan kit after the stove is
in its final location, follow same steps mentioned
previously with the exception of disengaging only the
right side of the outer shroud.
Rheostat
Retaining Nut
Control Knob
ST347a
Fig. 14 Attach rheostat to control panel. Valve may look
different.
Install ON/OFF Switch
The switch assembly parts are found in the parts bag.
1. Attach switch assembly to left rear side of stove
shroud using two screws and existing holes in
shroud. (Fig. 16)
2. Run wires down back of stove, under bottom of rear
shroud to valve.
3. Attach wires to valve terminals. (Fig. 17)
TP
TH
TPTH
ST228
Fig. 17 Attach switch wires to valve.
Existing
Holes
Switch
Assembly
Screws
ST315
Fig. 16 Attach switch assembly to rear shroud.
Thermostat Wire / Gauge Maximum Run
18 40 feet
20 25 feet
22 16 feet
Thermostat Connection (Optional)
Use only a thermostat rated for 500 - 750 millivolts.
Do not use low voltage (24V) thermostats.
Check the table below for the appropriate gauge
thermostat wire to use for the length of lead required in
your installation.
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4” female connectors.
2. Connect the thermostat wires to the valve. (Fig. 17)