Filter
Top Products
6
As with any product that performs automatic functions, there are certain safety precautions that you
must practice and be aware of.
1. Keep the transmitter out of reach of children.
2.
DO NOT leave anyone in the vehicle while running on remote control.
3. Alert any service personal that the vehicle can be started automatically.
4. DO NOT start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is corrected.
7. The use and operations of this security system is the sole responsibility of the owner/operator
of the vehicle
8. Some areas may have local ordinances that prohibit leaving a vehicle running on public
streets. Check your local laws and ordinances.
Warnings
Remote Start Operation
1. Press the button twice on the transmitter for about 1 second.
2. The parking lights will activate to indicate the remote start signal has been received.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after 11 seconds the parking lights will turn on again and climate
controls will activate and adjust the vehicle’s interior temperature to your preset setting.
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down
Note: The remote start unit will not start the vehicle if any one of the following conditions exists:
1. The Hood is open
2. The Brake Pedal is Pressed
3. Move the Optional Remote Start Enable Switch to “OFF” Position (If Installed)
4. The Gear Selector is in any Gear other than “Park” or “Neutral”
How to Remote Start Your Vehicle
1. Insert the ignition key and turn it to the “ON” Position. Be sure you DO NOT turn the Ignition key
all the way to the “Start” position. This will cause severe damage to all the starter components
on your vehicle.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the “ON” position, the engine will
automatically shut down
How to Operate the Vehicle While Running on the Remote Start Function
This feature allows the vehicle to remain running after the key has been removed from the ignition.
This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of
time but, would like to leave the motor running and climate control on.
1. Before turning off the engine, press the button twice on the transmitter and the LED
indicator will flash 3 times to confirm mode entry.
2. Turn the ignition key to “OFF” position (The engine will stay running)
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
Temporary Stop Feature
M7A-UM 6/14/06 14:44 Page 6