Filter
Top Products
1. Press the button on the transmitter.
2. The horn will chirp once and parking will flash once indicating that the system is now armed.
The vehicle’s door will lock upon arming when interfaced with the security system.
Tamper Disarming: (Optional Feature)
If the security system has been tampered with and activated, the siren will chirp 4 times and the
parking lights will flash 3 times.
Pathway Illumination: (Optional Feature)
This feature turns”On” the parking lights for 30 seconds upon disarming of the security system.
Arming the security system will leave the parking lights on for 10 seconds.
Two Step Door Unlocking: (Optional Feature)
This feature will independently unlock the drivers door only when disarming the security system.
Pushing the “Unlock” button a second time within 3 seconds will unlock the entire vehicle.
Automatic Re-Arm: (Optional Feature)
If this feature is selected, the security system will automatically re-arm itself 60 seconds after
disarming with the remote transmitter. Automatic re-arm will cancel if any door is opened before
the 60 second timer has elapsed.
Active Unlock & Disarm
4
The override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to “On” position.
2. Within 10 seconds push and release the valet switch, the security system will enter the Disarm
Mode. You can now start and operate the vehicle normally.
Disarming without a Transmitter
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to a parking attendant or garage mechanics. When the security system is in Valet
Mode, all functions and remote start functions are bypassed however, the remote panic feature and
remote door locks will remain operational. To use the Valet Mode, the security system must first be
disarmed either by using your remote transmitter or by operating the manual override sequence.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to the “On” position.
2. Push and hold valet switch for 2 seconds or until the “LED” turns on solid. The LED will
remain on as long as the system is in Valet Mode.
Exit Valet Mode:
1. Return to normal operation, turn ignition switch “On”.
2. Push and hold the valet switch for 2 seconds and the “LED” will turn off. This indicates the
security system is out of the Valet Mode.
Valet Mode
M7A-UM 6/14/06 14:44 Page 4