Filter
Top Products
MOUNTING THE THERMOSTAT TO THE WALL
8 LUXPRO
®
PSPU732T
1. Make sure to turn off the power supply located at the electrical service panel.
All heating and cooling units should be OFF.
2. Separate the backplate from the thermostat by grasping the unit firmly at the bottom lip and
pulling gently until the two piece are apart.
3. Align the backplate to the wall.
4. Mark the three locations for drilling the 3/16” holes required for the plastic screw anchors.
5. Remove the backplate and drill the three 3/16” holes in these locations.
6. Insert the plastic gyproc screws and ensure that they are snug in the wall.
7. Securely mount the backplate to the wall with the 3 supplied screws.
8. Make the appropriate wire connections based on the specifications of the
household HVAC unit(s). Please refer to Wiring Table to determine the appropriate wire connec-
tions.
9. Place the thermostat on the backplate by firmly but gently from the top aligning the pins with
the screw terminals.
10. Turn on the electricity at the electrical service panel.