Filter
Top Products
Maintenance 31
© Travis Industries 4080728 100-01156
Weekly Maintenance (or every 5 bags of pellets) - continued
Cleaning the Optional Gold Surfaces (Door and optional Grill)
Fingerprints or other marks left on gold surfaces may become etched in place if they are not wiped
clean prior to turning the stove on. Clean the gold with denatured alcohol and a soft cloth (make sure
the heater is cool). Other cleaners may leave a film that may become etched into the gold.
Clean the Baffles
WARNING : Make sure the heater has fully cooled (approximately 25 minutes) before conducting service.
Use both hands to lift each baffle up and forward. Then tilt the baffle downward to remove any flyash
that may have accumulated on top of the baffle.
NOTE : you do not need to remove the baffle from the firebox.
Lift the left side baffle up
and move it towards the
front of the stove. Rotate
the back of the baffle
forward.
b
c
d
e
The baffle rests on this ledge at
the back of the firebox.
Note how this tab inserts
into this slot in the baffle.
Repeat step “b” through
“d” for the right side
baffle.
a
Remove the refractory following the
directions below.
Left Side Baffle
Right Side Baffle
Lift the refractory up and
forward to remove.
Remove both refractory
side clips.
Remove the firepot.
Cleaning the Baffles
The baffles are located along the top of
the firebox. Follow the directions below
to remove the baffle and shake any
flyash from baffle onto the firebox floor
(NOTE: you do not need to remove the
baffle from the firebox).
Heat Exchange Tubes
Left Side Baffle
With the baffle free of the ledge,
bring it downwards and tap any
flyash onto the floor of the
firebox.
To replace the baffles:
follow the above procedure in reverse.