Filter
Top Products
6 Specifications
Travis Industries 4050418 100-01156
Heating Specifications:
Approximate Maximum Heating Capacity (in square feet)* ........................................800 to 2,250 Sq. Feet
Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5
Maximum Burn Time on Low Burn** ......................................................................47 Hours
Hopper Capacity ..............................................................................................80 Pounds
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also affected
by the fuel size, quality, and moisture level.
** Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel
quality may occur.
Dimensions:
Air Inlet
(1-3/4"
Outside
Diameter)
Weight: 225 Lbs.
4"
Diameter
Exhaust
9-1/4"
16-1/2"
13"
5-1/4"
32"
23"
25"
This tab can be bent
out and used to hang
the scraper rod tool.
Electrical Specifications:
Electrical Rating.........................................................................................115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence...................................................................400 (approximately)
Watts During Operation ...............................................................................180 (approximately)
Fuel:
The unit is designed for wood pellets that comply with the standards set by the Association of Pellet Fuel
Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than 1–1/2", 8200
BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). If the fuel
does not comply to this standard, the unit may not operate as designed.
NOTE : This heater may use alternative fuel if equipped with the multi-fuel fire pot and properly maintained. See the
publication “Multi-Fuel Pellet Fire Pot” for requirements (available from your Travis Industries, Inc. dealer).
EPA Compliance:
This heater has been tested exempt from EPA Phase II Requirements by OMNI Test Labs.