Filter
Top Products
32 Maintenance
Travis Industries 4050418 100-01156
Yearly Maintenance (or every two tons)
WARNING: Disconnect the power cord prior to conducting service.
The following section details extensive maintenance procedures. We strongly suggest these items
be carried out by a trained service technician, possibly by a service agreement set up with your dealer.
Soot and Flyash: Formation and Need for Removal – The products of combustion will
contain small particles of flyash. The flyash will collect in the exhaust venting system and restrict the
flow of the flue gases. Incomplete combustion, such as occurs during startup, shutdown, or incorrect
operation of the room heater will lead to some soot formation which will collect in the exhaust venting
system. The exhaust venting system should be inspected at least once every year to determine if
cleaning is necessary.
Clean the Vertical Exhaust Duct (the stove must be cool and unplugged)
Remove both refractory
side clips.
Lift the refractory
up and forward
to remove.
Remove the firepot.
Clean the refractory and
the entire area behind it
(both sides).
Refractory
Remove these doors to
remove fallen flyash and soot
(see “Bi-Weekly Maintenance”)
Clean the Exhaust Duct
(the stove must be cool and
unplugged)
Clean the Convection
Blower
(the stove must be cool and
unplugged)
The convection
blower inlet can
be vacuumed
out (if needed).
If extensive
cleaning is
needed, it can
be removed for
cleaning.
Remove the
cover plates over
the exhaust duct
(both sides)
b
Swing the side panels open.
7/16" Nutdriver
c
Cover Plate
Use a vacuum or bottle
brush to remove all
flyash from the exhaust
duct (if the gasket is
damaged, replace).
a
Phillips
Screwdriver
Open the hopper lid and remove the two
screws holding the side doors in place.
d