Filter
Top Products
Stove Installation (for qualified installers only) 7
© Travis Industries 100-01179 4060926
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure
to follow instructions may result in property damage, bodily injury, or even death.
Contact local building or fire officials about restrictions and installation inspection
requirements in your area.
Always use gloves when operating a hot stove. The door handle and other components become very
hot during normal use.
Planning The Installation
We suggest that you have an authorized Travis Industries dealer install your stove. If you install the
stove yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this stove and notify your
insurance company before proceeding with installation.
Preparation for Installation
The stove can be lightened by removing the firebricks and baffle (pg 29) - replace before operation.
• Check for damage to the exterior of the stove.
• Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
• The door (shipped separately - SKU 96100612 or 96100724) must be installed prior to operation.
• The stove must be placed on legs (see page 34) or a pedestal (see page 34).
Stove Installation Considerations
The table below details the six most common types of installations and the considerations for each type.
Alternative methods of installation are available if they comply with local building codes.
Installation Type Considerations
Standard Ceiling with a Factory Built Chimney
(Page 15)
• Requires ceiling and roof penetration
• Provides best draft
Cathedral Ceiling with a Factory Built Chimney
(Page 15)
• Cathedral style chimney support required
• Provides best draft
Hearth Stove Positive Connection
(Page 16)
• Utilizes existing masonry fireplace (not approved for zero
clearance (metal) fireplaces)
• Provides good draft due to full reline
• Easier to clean than direct or horizontal hearth stove
Hearth Stove Direct Connection
(Page 17)
• Utilizes existing masonry fireplace (not approved for zero
clearance (metal) fireplaces)
• Requires construction of a "block-off plate"
• Draft reduced due to elbows & chimney cross section
Interior Masonry Chimney
(Page 17)
• Utilizes existing masonry chimney (not approved for zero
clearance (metal) fireplaces)