Filter
Top Products
COMPONENT IDENTIFICATION LISTING
ITEM PART # DESCRIPTION QTY ITEM PART # DESCRIPTION QTY
1 Per Model Operator Power Head 1 8 009149 Release Chain AR
2 005031 3 Button St ation 1 9 100315 #3 Hand Chain - Precut to 26 FT AR
3 105270 24 Tooth, #50 Chain Sprocket (Standard) 1 10 105349 #50 Drive Chain - 6 FT Long 1
4 105268 12 Tooth, #50 Chain Sprocket (Standard) 1 11 105351 #50 Chain Connecting Link 1
5 105193 Release/Hand Chain Wall Bracket 1
6 100413 1/4” Square Key 2
AR - AS REQUIRED
7 006119 5/16-18 x 1 Square Head Set Screw 4
TO REDUCE THE RISK OF SEVERE
INJURY OR DEATH:
WARNING
• Install only on a properly operating and balanced
garage door. A door that is operating improperly
could cause severe injury. Have qualified service
personnel make repairs to cables, spring
assemblies and other hardware before installing the
opener.
• Remove all pull ropes and remove, or make
inoperative, all locks (unless mechanically and/or
electrically interlocked to the power unit) that are
connected to the garage door before installing the
opener.
• Lightweight doors (fiberglass, aluminum etc.)
must be reinforced to avoid door damage. Check
the door manufacturer’s instruction manual for a
bracing procedure or the availability or a
Reinforcement Kit. See Page 9.
• Model J and H are Commercial Vehicular Door
Operators and as such ARE NOT recommended
for pedestrian traffic. In installations where it is
known that pedestrians will be nearby ensure a
pedestrian door is available for entrance and exit to
the building. In addition YOU MUST install an
auxiliary entrapment protection device (reversing
door edge or photoelectric beam device).
• Connect an auxiliary entrapment protection
device (reversing edge or photoelectric device
across the door opening). A device of this type is
STRONGLY ADVISED FOR ALL commercial
operator installations. An auxiliary entrapment
protection device is REQUIRED when the three
button control station is out of sight of the door or
any other automatic or manual control is used.
• Install the door operator at least 8 feet or more
above the floor if the operator has exposed
moving parts.
• Do not connect the opener to the source of
power until instructed to do so.
• Locate the control station:
a) within sight of the door,
b) at a minimum height of five feet above the
floor so small children cannot reach it,
c) away from all moving parts of the door, and
d) far enough away from the door, or positioned
such that the user is prevented from coming in
contact with the door while operating the
controls.
Do not overtighten the clutch adjustment to
compensate for a poorly working door.
Install the Entrapment Warning Placard next to
the control station in a prominent location.
All warning signs and placards must be
installed so they are visible in the area of the door.
After installing the opener, all safety features
must be tested for proper operation (see page 19).
For products having a manual release, instruct
the end user on the operation of the manual
release.
5
IMPORTANT INSTALLATION INSTRUCTIONS!
READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS!