Filter
Top Products
Architectural Decorative IS:CCLPS602P
Page 2 of 4 Instruction Sheet for Assembly and Installation
Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • A0908
Wiring:
After mounting the power/data supply, you are ready to connect power, lumi-
naires, and data to CCLPS602P.
Connecting Luminaires to CCLPS602P
• Plug the leader cable connector into a power output receptacle on the front
of CCLPS602P. Power outputs are labeled Out 1 and Out 2. (See Fig. 2.)
Note: When using one luminaire run per CCLPS602P, use Output 1.
OUT 1
OUT 2
ENET IN
DMX IN
DMX OUT
To Luminaires
Fig. 2
• Refer to the user guide for your luminaires to determine maximum number of
luminaires per power/data supply and specific wiring requirements.
Connecting DMX Data:
CCLPS602P receives DMX data from, and can be controlled by, Lightolier’s full
line of DMX512 controllers or any third party DMX512 controller.
• Plug the data RJ-45 connector from the controller into the DMX IN port.
• To daisy-chain DMX data to another CCLPS602P, connect a CAT5 cable with
RJ-45 connectors between the DMX OUT port of the first unit and the DMX
IN port of the next unit. Plug a terminator into the DMX OUT port of the last
power supply in a data chain. (See Fig. 3.)
OUT 1
OUT 2
ENET IN
DMX IN
DMX OUT
To Luminaires To Luminaires
OUT 1
OUT 2
ENET IN
DMX IN
DMX OUT
DMX IN DMX OUT DMX IN Terminator
Lightolier
®
DMX or
Color Rotary Dial Controller
Fig. 3
Connecting Power:
• Connect the IEC power cable to the back of unit. Plug the IEC power cable
into a standard 100-240VAC outlet. Tighten the screw to secure the clamp.
(See Fig. 5.)
Note: If power supply does not power up (front display is blank) make certain
power cable is firmly inserted into the receptacle on the back of the unit.
Tighten Screw
To Lock
Fig. 5