Filter
Top Products
NSTRUCTION SHEET NO.
1S:5412
1291 Page 2 of2
A. INSTALLATION OF FIXTURE BODY
1. Remove both DIFFUSERS from FIKTURE BODY bygentlygrasping DIFFLfSERtowards end and pulling direc+yawayfrom DIFFUSER
PAN.
2. Hook HANGER LOOP over one of the HANGER TABS on MOUNTING PLATE and allow FIXTURE BODY to hang.
3. Make connections black fixture leads or fixture leads without trac?r marks to blask (hot) supply lead? white fixture leads or fixture leads
with tracer marks to white (neutral) supply leads. Uninsulated fixture wires are ground wires and all must be sbnnected to grounding
terminal or wire in “outlet box”. Use wirenuts (local hardware item).
CAUTION: Push supply wires and wirenut connections back into outlet box.
\
4. Position FIXTURE BOOYover MOUNTING PLATE and gently push FIXTURE BODY against wall until both MOUNTING STUDS soma
through the SLOTS in DIFFUSER PAN. Sesure in plain using STAR WASHERS and BATTERY NUTS.
CAUTION: Make certain that no wireaare pinchadbefween mounting plata and tixfure body.
5. InstallrecommendedlampsbyengaginglampbaseintoSOCKETandthensnappingintoLAMP CLIP.
6. Position open end of DIFFUSER into FIXTURE BODY@ and gantfy pueh DIFFUSER beck against DIFFUSER PAN until DIFFUSER
snaps into plaw @onto DIFFUSER CLIP. Repeat for second DIFFUSER.
NOTE: Support the back side of DIFFUSER PAN before snapping DIFFUSER into plats.
CAUTION: Uae lamp types/wattages ae marked on fixture. For horizontal mounting onfy.
e
‘o
,’
*