LG Electronics BG-123A Air Conditioner User Manual


 
1.4 FEATURES
• Designed for cooling only.
• Powerful and quiet cooling.
• Top-down chassis for the simple installation and service.
1.5 CONTROL LOCATIONS
1.5.1 COOLING ONLY MODEL
• OPERATION
• Side air-intake, side cooled-air discharge.
• Built in adjustable THERMISTOR and THERMOSTAT.
• Washable one-touch filter.
• Compact size.
• VENTILATION
Push the lever to the "CLOSE" position to cool, heat or recirculate room air only.
Pull the lever to the "OPEN" position to exhaust smoke or stale air from the room.
This feature is best used in conjunction with the FAN ONLY position.
5
PULL OPEN / PUSH CLOSE
MODE TIMER POWER
FAN
SPEED
Fan
Energy
Saver
Cool
Timer
TEMP
'
F
F1 LOW
F2 MED
F3 HIGH
REMOTE CONTROL SIGNAL RECEIVER
POWER
MODE
-
Push this button to shift mode of operation from COOL ENERGY SAVER FAN.
- COOL:
Fan runs continually for normal cooling operation.
- ENERGY SAVER:
The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air
temperature to determine if cooling is needed.
- FAN:
Fan-only operation.
TIMER
- SHUT-OFF TIME
You will usually use shut-off time while you sleep.
If unit is running, use Timer to set number of hours until shut-off.
For your sleeping comfort, once Time is set, the Temperature setting will raise 2°F after 30 min., and once again after another 30 min.
Push Timer button to advance setting from 1Hour 2Hours ... 12Hours maximum.
- START TIME
If unit is off, use Timer to set number of hours before unit starts.
Push Timer button to advance setting from 1Hour 2Hours ... 12Hours maximum.
TEMPERATURE SETTING
Use this button to automatically control the temperature of the room.
The temperature can be set within a range of 60°F to 86°F by increments of
1°F.
The setting appears in the display.
To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
This button takes priority over any other button.
When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72°F.
FAN SPEED
Every time you push this button, it advances the setting as follows:
{High Low Med High}
When the air conditioner has been operating in the
cooling and is turned off or set to the fan only position,
wait at least 3 minutes before resetting to the cooling
operation again.
CAUTION