Filter
Top Products
PROCEDURE
If you are using the new sleeve (optionally
A
suppliedwithyourunit),skiptostep3.
Otherwise, install the plastic grille from the kit.
Cut the plastic grille to 25-1/2" wide and
15-1/4" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressing into the square holes
of the rear flanges.Fasten the bracket to the
upside of the wall sleeve using the washer
screw. The bracket prevents the unit from
leaving the sleeve.
Remove the backing from the Vertical
Insulation strip 15
9
/
16
x1
3
/
8
x1
3
/
8
and attach that
totheinsiderightofthesleeveasshown
below. Remove the backing from the Around
Insulation strip 67
1
/
8
x1
3
/
8
x
25
/
32
and attach that
to the inside front of the sleeve as shown
below.
FIG.20
Around Insulation
9
1
/
2
"6"
Indoor Outdoor
FIG. 22
or
Bracket Bracket
FIG.21
Fasten the screws and the bracket
1
2
3
4
5
Wall
Trim (2 ea)
FIG.23
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to avoid
cuts from sharp metal fins on front and rear coils.
• Make sure air conditioner does not fall during
removal.
• If unit does not operate after installation check, to be
sure the circuit interrupter has not been tripped. Refer
to the Troubleshooting guide for reset procedure.
CAUTION
Install the new unit into the wall sleeve.
Toassembletrim,tpthetabofeachpiece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
—15—