Filter
Top Products
506920−01 09/12
Page 16
Adjust a setting... Configure Humiditrol
®
or Auxiliary Dehumidifier
edit
about
To adjust a setting,
highlight it,
then press Edit
System
reinstall
edit
reset
Dehumidification Control Mode
current value:
back
Midpoint Overcooling
Pre−adjustment REQUIREMENTS:
1st, the device has been installed (see Page 12).
2nd, from the Add or Remove Non−communicating equipment?", press next.
3rd, in the Adjust a setting..." screen, configure the device as follows:
1. In the system devices" list, use the arrows (1a) to highlight System. Press
edit (1b).
2. Humiditrol
®
onlyĊIn the System" list, use the arrows (2a) to highlight
Humiditrol Comfort Adjust. The current value defaults to Maximum Over-
cooling. Press edit (2b).
3. Humiditrol
®
onlyĊTouch one of the radio buttons (3a) to select the over-
cooling level; press save (3b). (After saving, check that the current value
now shows the new selection).
4. Use arrows (4a) to highlight Min Dehumidification Setpoint; press edit
(4b). Note the current value (e.g. 45).
5. Use arrows (5a) to make changes; press save (5b). (After saving, check
that the current value now shows the new selection).
6. Press the back button to return to Adjust a setting..." screen.
1a
1b
2a
system devices
System
Air Conditioner
Furnace
Thermostat
Humiditrol
Maximum Overcooling Midpoint Overcooling
Minimum Overcooling
Select one
Humiditrol Comfort Adjust
cancelsave
3b
3a
System
3rd Stage Delay
4th Stage Delay
Lock In 2nd Stage HP by Outdoor Temp
Balance Point Control
Humiditrol Comfort Adjust
Min Dehumidification Setpoint
edit
reset
back
Dehumidification Control Mode
current value:
45
9:39 am Aug 15, 2012
4a 4b
Humiditrol Comfort Adjust settings are
only available on units equipped with
a Humiditrol
®
dehumidification device.
See Page 18 for description of Min/
Mid/Max overcooling.
resetAll
2b
6
Min Dehumidification Setpoint
Range is 40 to 60
Default is 45, inc:1
cancelsave
set−to
42
5a
5b
(returns to
adjust a
setting
screen)
System
Staged Delay TImers
2nd Stage Delay
3rd Stage Delay
4th Stage Delay
Lock In 2nd Stage HP by Outdoor Temp
Balance Point Control
Humiditrol Comfort Adjust
Min Dehumidification Setpoint
OD/Humid Boundary
Outdoor Temperature Reading Calibr
Figure 15. Adjust a non−communicating device settingĊDEHUMIDIFIER