Filter
Top Products
506920−01 09/12
Page 42
Table 3. Adjustable Parameters Table (Installer)
Parameter Name Installer entryNoteDependencyIncr.Max.Min.Default
Other Parameters
Equipment Name Furnace N/A N/A N/A None Up to 35 characters
Continuous Indoor Blower Airflow DIP SW (See
Note 3 at
end of table)
Min
CFM
Max
CFM
25 None 1/2 HP blower
Min
CFM
Max
CFM
25 1 HP blower
Humidification Airflow Same as
above
Min
CFM
Max
CFM
25 Humidifier present 1/2 HP blower
Min
CFM
Max
CFM
25 1 HP blower
Dehumidification Airflow Percentage 140
(=70%)
120
(=60%)
160
(=80%)
2
(=1%)
OU present and SC
(Subnet Controller)
algorithm support
Percent of High Cooling
Airflow
Note 1: Minimum Outdoor Unit Cooling Stage as a percentage of High Cooling Airflow (value is rounded up to the closest number on 25 CFM resolution.
Note 2: Minimum Outdoor Unit Heating Stage as a percentage of High Heat Pump Airflow (value is rounded up to the closest number on 25 CFM resolution).
Note 3: All communicating Installer Parameters default CFM values based on DIP switch setting (non−communicating value) are calculated using the CFM conversion
tables and rounded up to closest number on 25 CFM resolution.
Note 4: Parameter dependency − Certain parameters are dependent on others and may not be shown on the display.
Note 5: Default Values − Jumper/DIP switches impact the default value of some parameters.