Lennox Hearth SDVSS-25/35 Stove User Manual


 
9
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
14-7/8”
(378mm)
18-1/2”
(470mm)
32-1/2”
(826mm)
Rear Vent Dimensions
Dimensions
The gas line attaches to the gas valve at the back of the stove 2-1/2” in
from the left side of the stove and 8-1/2” up from the base of the unit.
Test all gas connections for leaks with a gas leak test solution.
Preparing Your Appliance For Installation
Read all instructions before beginning your installation. If instructions
have not been read carefully, your installation could void your warranty
and may create a serious fire, health, or other safety hazard.
The Lennox Hearth Products warranty will be voided if one of the fol-
lowing occurs:
• Installation of any damaged stove or vent system component.
• Unauthorized modification of the direct-vent system.
• Installation other than as instructed by Lennox Hearth Products,
Security Chimneys™, or Simpson Dura-Vent.
• Installation of any stove or vent system component not manufac-
tured or approved by Lennox Hearth Products, Security Chimneys™,
or Simpson Dura-Vent.
When planning the installation for your appliance, it’s necessary to
consider the following:
• Where the unit is to be installed
• The vent system configuration to be used
• Gas supply (NG or LP)
• Electrical wiring
• Optional accessories (door trim/grill assembly and wall-mounted
or remote thermostat)
Top View
Front View
Figure 1
Figure 2
Figure 3
Flue Collar
24-3/4”
(629mm)
28”
(711mm)