Filter
Top Products
10
Firebox Accessories / Parts
Cat. No. Description
H5861 Log Set
H5863 Bag of Embers (volcanic stone)
H5864 Bag of Rockwool (glowing embers)
H5865 Bag of Steel Wool
Log Installation Instructions
If logs are not installed according to the log installation in-
structions, flame impingement and improper combustion could
occur and result in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic gas.
The size and position of the log set is critical to achieve a safe,
reliable and attractive flame pattern. Any attempt to use a differ-
ent log set in the fireplace will void the warranty and will result
in incomplete combustion, sooting and poor flame quality.
Parts list: rear log, left front log, right front log and straight twig
1) Remove the logs from the box and carefully unwrap them. The logs
are fragile so handle them with care.
2) Align the holes in the bottom of the rear log (the longest log in the set)
with the two pegs just to the rear of the rear burner tube and slide the
log down onto the pegs (Figure 10). The charred black surface of the
log should face the front.
3) The left front log has two pegs protruding from the top surface (Fig-
ure 11). The charred black with white highlights surface of the log
should be facing forward. Slide this log down onto the left front and
center front pegs.
4) The right front log (positioned with the black charred surface towards
the front) should be placed on the peg protruding from the right end
of the left front log and the remaining peg at the right end of the metal
log support panel (Figure 11).
5) The remaining straight twig has two holes in the bottom. Position the
twig so the black and white charring is to the front and slide the holes
over the peg in the left front log and the peg in the rear log (Figure
12). It may be necessary to roll the top of the rear log slightly forward
to put this twig on the pegs.
6) Figure 13 shows the entire log set assembled. The embers provided
may be placed one high in front of the front burner tube using care not
to cover all the burner ports. Any extra embers may be placed at the
ends of the front log, off the burner. Place small pinches of rockwool
on top of the embers.
Baffle and Log Set Installation
Baffle
The cast iron baffle is wrapped in foam and shipped between the outside
of the firebox and the outer shell of the stove. Remove the foam and install
the baffle in the rectangular hole in the top of the firebox. The baffle rests
unsecured in the hole.
Log Set and Embers
Figure 10
Figure 11
Figure 12
Pilot Viewing
Embers
Figure 13
Note the location of the hole for viewing the
pilot light. When the pilot is burning, a
blue flame can be seen through
this hole.
INSTALLATION