Filter
Top Products
8
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 3
Figure 2
3. First, screw the threaded rods into the holes at the four corners on the
bottom of the stove. Screw the threaded rods into the firebox three
full rotations or 3/16” to 1/4” (if the rear rods are screwed in too far
they will lift the bricks off the bottom of the stove). Use a washer
and nut to secure the leg. Be sure the legs are mounted squarely on
the firebox bottom. Tighten nuts securely.
4. Use the two bolts and washers provided with the heatshield kit to
mount the heatshield as shown in Figure 3.
5. Do not over tighten the heatshield mounting bolts as it may bend the
heatshield.
To locate the hole in the hearth for outside air, mark a 4” circle on the
hearth. The circle’s center should be 2-3/4” directly back from the center
of the flue outlet and 5/8” to the left side.
Figure 4
Expanded View
of Clip
Residential and Mobile Homes - Bolting down and grounding of stove
are required only in mobile homes.
Open all cartons, if any and remove the contents upon receipt and check
for any damaged or missing parts. If there is hidden damage, notify your
freight company or Lennox Hearth Products dealer immediately.
CAUTION: Wear gloves during installation in case of sharp
edges on the stove.
Leg Installation
1. Carefully place stove on its back. Be careful not to scratch the stove,
use a piece of cardboard or carpet to protect the back of the stove.
2. Mount all four legs as shown in Figure 2
.
Line up the hole in the clip with the hole in the
rear center of the bottom heatshield
LEG AND HEATSHIELD INSTALLATION
OUTSIDE AIR KIT INSTALLATION
To install the “Outside Air Kit”, position the clip so that the nut is directly
above the hole punched in the back of the heatshield (see Figure 4).
Install the outside air adapter box on the stove by sliding it into the air
channel located between the bottom heatshield and the stove bottom until
the oblong ring is approximately 1/4” from the rear edge of the lower
heatshield. Make sure the ring is facing down. Thread the bolt up through
the nut in the clip until snug against the adapter box.
Threaded Rod
Washer
Nut
Air Channel
Heat Shield
Mounting Holes
FRONT
BACK
Clip
1/4” Bolt