Filter
Top Products
2
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Figure 3
Step 2. Remove Faceplate Screws and Washers - Partially peel back the
door gasket, to expose the six screws and washers (see Figure
4). Note: Peel the gasket back just enough to get your 5/32” allen
wrench on the screws (see Figure 5). It is very important not to
pull the gasket all the way off the door. If the gasket becomes
hard to pull, you have gone too far. Fragile care should be taken
when working around the door rope junction.
IMPORTANT NOTE: Be sure not to over tighten the screws. If the screws
are over tightened the glass may crack when the stove is hot.
Figure 4
Figure 5
Step 3. Remove Faceplate - Be advised that the faceplate also functions as
a glass retainer (see Figure 6). Make sure to apply inward pres-
sure on the glass while removing the faceplate. IMPORTANT,
PRESS THE GLASS INWARD TO ENSURE THE GLASS STAYS
IN THE GROOVE AND DOES NOT FALL OUT AND BREAK.
Figure 6
Figure 2
Spring Handle
INSTALLATION INSTRUCTIONS
Step 1. Remove Spring Handle - Twist spring handle clockwise and pull
down at the same time to remove from handle rod (see Figures
2 and 3).
Rotate spring handle
clockwise to remove
Allen head screws
indicated by arrows
Allen Wrench
Allen Head Screw
and Washer
Faceplate