Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
5
ASSEMBLY OUTLINE
Before You Start
Check your inventory list to be sure you have
all the necessary parts supplied in good us-
able condition. Check also for any concealed
damage.
UNIT PRE-ASSEMBLY
Before the installation can begin, two compo-
nents need to be assembled.
Dust Cover Assembly
The dust cover components come wrapped in
foam. There are five (5) parts to the assembly,
as shown in
Figure 5
.
Using the illustration for guidance, assemble
the components. Use the tabs to lock the
components together by bending each inward
as illustrated. Bend out the base tabs as
shown, to act as latches for installation later.
Set the assembly aside for installation later.
Figure 5
Figure 6
Television
(Face Down)
Television
Straps
Secure Television
Straps Tightly
Tray
Assembly
Base
Support
Television
Base
Handles
Spacers
Television Assembly
Lay the television tray assembly onto a flat
surface. Use a cardboard protector to protect
the tray from marring.
Open the television box and remove all pack-
ing materials from the unit. Remove the tele-
vision and place it beside the tray.
Note: The Television is provided with a remote
control. The fireplace does not require this
remote control. It may be discarded.
Untie the straps on the tray assembly and
loosen them completely. Drape the straps out
of the way as much as possible.
The television will lay face down on the tray as
shown in
Figure 6
. The television is oriented
centrally on the tray with the bottom against
the base support. The straps are then doubled
over the unit as shown in
Figure 6
and drawn
very taut. Lift the assembly up onto its base
(as shown in
Figure 9
) and verify the security
of the straps. Use the handles on each side of
the unit to lift and hold the unit.
Note: The TV screen protrudes below the
bottom frame of the tray assembly. Be sure to
support the tray assembly above the work
surface to protect the TV screen. Use the
spacers from the TV box to do this.
CAUTION: THE SECURITY OF THE STRAPS
IN THIS ASSEMBLY IS IMPORTANT SO THAT
THE INSTALLATION STEPS THAT FOLLOW
CAN BE PERFORMED SAFELY.
Locking
Tab Bent
Into Place
Front/Back
Side
Side
Top
Base
Tabs