Filter
Top Products
INSTALLATION
PAGE 14
GAS APPLIANCE FINAL ASSEMBLY (ALL MODELS)
After the appliance has been properly installed and all gas con-
nections have been made and tested, you can now install the
log set.
INSTALLING LOG SET:
WARNING: If logs are not installed according to the direc-
tions in this manual, flame impingement and improper com-
bustion could occur and result in excessive production of
carbon monoxide (CO), a colorless, odorless, toxic gas.
This appliance is equipped with a five-piece log set. Carefully
install the logs into the firebox as shown on this page. All logs
should fit down onto pins and mounts provided. This will en-
sure a proper flame and safe combustion.
1. Carefully place the largest log in the rear of the firebox as
shown in the following illustration.
2. Install the front log and embers as shown in the following
illustration.
3. Install the right top twig as shown in the following illustra-
tion.
4. Install the center top twig as shown in the following illus-
tration.
5. Install the left top twig as shown in the following illustra-
tion.
Glowing Embers
Two packages of ember material have been included with the
gas appliance. Unpackage and divide the fine ember material
(mineral wool) into thumbnail sized pieces. Distribute the
pieces over the top of the front burner ports, filling the area in
front of the forward log and running the full length of the
burner.