Filter
Top Products
42
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 72
Figure 73
Step 9. Reassemble the remaining components
by reversing the procedures outlined in the
preceding steps.
Use pipe joint compound or Teflon tape on all
pipe fittings before installing (ensure propane
resistant compounds are used in propane ap-
plications, do not use pipe joint compounds
on flare fittings).
Step 10. Attach the conversion label provided
in the conversion kit to the rating plate on the
appliance.
Step 11. Turn on gas supply and test for gas
leaks.
ALWAYS TEST PRESSURE WITH THE VALVE
REGULATOR CONTROL AT THE HIGHEST
SETTING
B. Install the burner as shown in Figure 73.
Ensure that the arm of the venturi of the burner
is hooked onto the air shutter adjustment lever
(refer to Figure 67 on page 41).The primary air
opening can be adjusted by rotating the adjust-
ment lever from beneath the firebox floor. Refer
to Figure 65 on page 36 for the recommended
minimum primary air opening setting.
BURNER POSITIONING
PAN
BURNER
PILOT ASSEMBLY
Burner Orifice Sizes (all models)
Elevation
Feet (meters)
Natural
Gas
drill size (inches)
Propane
Gas
drill size (inches)
0-4500
(0-1372)
(0.125")
*
21L81 •
#41
(0.096")
*
21L82 •
Table 9
* Standard size installed at factory
• Part /Cat. Number