Filter
Top Products
Example:
There are 4 smoke alarms and 3
Carbon Monoxide alarms that
need to be monitor in your
household. You will need seven
KA300TX transmitters. All
seven transmitters will be set
at the same operation code
as: 1000101010
If you use the KA300 system with the weather channel, hurricane, tornado, or
earthquake alarms combine with the fire alarm as illustrated in figure 8, you can choose
for the weather alert at channel 3. Set the same house code for these KA300TX units
and channel jumper to be channel 3.
INSTALL KA300 FOR SINGLE-FAMILY HOME.
Plan the location of the
KA300RX. Refer to Figure 8 to
find the ideal spot to install the
receiver for your house. Hallway
or living room will be a perfect
spot to install the receiver.
Since KA300 system is only an
alarm monitor system, you must
create a fire protection plan for
your family and practice the plan
to make sure that every member in
the family knows what to do when
the alarm triggers. Buy one or two
KA300RX receivers and install
them where they can be seen from
every room in the house.
If you have a 2 story house, each story needs to have one KA300RX receiver. The
programming process for the KA300RX receiver will be discussed later in Chapter 3.
1: HOW YOUR ALARM MONITOR KA300 WORKS (CONT.)
3
The other three transmitters will be set at
channel two.
Four transmitters installed on the smoke
detectors will be set at channel one.
FIGURE 6 FIGURE 7
CH3
CH2
CH1
CH3
CH2
CH1
FIGURE 5
Channel Jumper Channel Jumper
Operation Code Switches
Cover
FIGURE 8