- 7 -
Assembly
NOTE: Make certain that the dust
filter ᕣ is always inserted before
using the appliance.
1. To open the dust collector ᕢ, turn the
dust collector ᕢ clockwise and pull it
off the motor unit ¿.
Make certain that the dust filter ᕣ is
inserted and put the dust collector ᕢ
back on. Turn the dust collector ᕢ
anti-clockwise until the arrow symbol
points to the dot on the motor
unit ¿.
2. If the nozzle attachment ᕡ is requi-
red, insert this into the suction
opening on the dust collector ᕢ.
Operation
1. Remove the hand vacuum cleaner
from the charging station ᕧ. Using
the supplied plugs and screws ᕨ the
charging station can optionally be
mounted on the wall.
2. To switch the appliance on, move the
on/off switch ᕥ to the position "I".
3. After use place the on/off switch ᕥ
into position “O“.
4. The nozzle attachment ᕡ is used to
clean narrow, hard-to-reach areas.
Put the assembled hand vacuum clea-
ner in the charging station ᕧ and
start the charging process when the
vacuum power is noticeably weaker.
Cleaning
Changing and cleaning the dust filter
To achieve the best results, empty the
dust collector ᕢ and clean the dust
filter ᕣ after every use.
1. To open the dust collector ᕢ, turn the
dust collector ᕢ clockwise and pull it
off the motor unit ¿.
2. To remove the dust filter ᕣ from the
motor unit, turn it clockwise and pull
it off the motor unit ¿.
3. Empty the dust collector ᕢ.
4. Clean the dust filter ᕣ in cold water
and wait until it is completely dry be-
fore putting it back on the motor unit ᕤ.
5. Place the dust filter ᕣ on the motor
unit ᕤ. Turn the dust filter ᕣ anti-
clockwise to attach it. Never use the
hand vacuum cleaner without the
dust filter ᕣ inserted.
6. Put the dust collector ᕢ back on.
Turn the dust collector ᕢ anti-clok-
kwise until the arrow symbol points
to the dot on the motor unit ¿.
ƽ Important! The suction opening
must always be open and unblocked.
Blockages lead to overheating and
damage to the motor.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 7