Filter
Top Products
- 6 -
Before the First Use
1. The cordless hand vacuum cleaner is
powered by rechargeable Ni-MH bat-
teries. Before using the cordless hand
vacuum cleaner for the first time, the
batteries must be charged for at least
24 hours.
2. The batteries reach their full capacity
after a charging time of 24 hours. The
cordless hand vacuum cleaner can be
used for its full operating time when
the batteries are fully charged. Only
place the appliance back in the char-
ging station ᕧ once the vacuum po-
wer becomes noticeably weaker.
Charging
1. Insert the round plug of the power
supply into the back of the charging
station ᕧ. Lock the plug by turning it
anti-clockwise.
2. Place the charging station ᕧ next to
a power socket and plug the power
adapter in.
The charging station can optionally
be mounted on a wall with the supp-
lied screws and plugs ᕨ (see Chapter
„Mounting the wall bracket“).
Vertical screw spacing 102 mm,
screw diameter 3,5 mm.
You can insert the nozzle attachment
ᕡ into the socket on the charging
station ᕧ to store it.
3. Place the hand vacuum cleaner in
the charging station ᕧ.The charge
indicator light ᕦ lights up red and
the charging process begins.
NOTE: Make certain that the on/off
switch ᕥ is in position "0" before
starting the charging process.
ƽ Important:
• Once the charging process is comple-
ted, the appliance automatically swit-
ches to the charge maintenance func-
tion. However, in order to avoid possi-
ble damage to the batteries, do not
leave the appliance constantly con-
nected to the charging station .
• Only place the appliance back on the
charging station ᕧ once the vacuum
power becomes noticeably weaker.
ƽ Important information about the
battery
In the event of a defective battery,
please contact our service centre di-
rectly. Please refer to the guarantee
card for the Authorized Service Outlet
in your country.
Mounting the Wall Bracket
1. Bore two holes with a spacing of
ca. 102 mm. Using the wall bracket ᕧ
to mark the boreholes ensures the
correct spacing.
2. Push the plugs ᕨ into the boreholes
and screw in the lower screw ᕨ until
ca. 3mm is protruding.
3. Place the wall bracket ᕧ on the lower
screw.
4. Guide the upper screw ᕨ through the
wall bracket ᕧ and into the borehole,
then screw it in.
5. Tighten both screws ᕨ down.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 6