Filter
Top Products
2. Prepare the Site
NOTE: Portrait interface shown, landscape interface also available.
NOTE: Allow for a 1/4″ (6 mm) overlap for the lip of the wall sleeve and a minimum clearance of 1/2″
(1.3 cm) around the back of the opening to enable the clips to fully engage.
Refer to the rough-in information. With a pencil, mark the cut lines onto the finished wall.
Carefully cut out the opening in the finished wall following the penciled guidelines.
For thin finished wall materials of less than 3/16″ (5 mm), shim around the back of the opening to
provide adequate support for mounting the interface wall sleeve.
1/4" (6 mm)
Interface lip
Cutout
Wall
Shim
Clamp Arm
7-11/16"
(19.5 cm)
3-11/16"
(9.4 cm)
52" (132.1 cm)
1/2" (1.3 cm) Min
Clamp Arm
Clearance
3/16" (5 mm) Min –
2" (5.1 cm) Max Depth
1043184-2-B 6 Kohler Co.