Filter
Top Products
1. Install the Faucet
NOTE: If possible, install the faucet to the sink before installing the
sink.
Slide the O-ring over the flexible hose, sensor cable, and threaded
stud. Position the O-ring into the groove in the base of the faucet.
Run the flexible hose, stud, and sensor cable through the
mounting hole of the sink.
Slide the bracket, washer, and nut onto the threaded stud from
underneath the sink.
Securely tighten the nut against the underside of the sink. Do not
overtighten the nut.
Install the sink at this time. Refer to the sink manufacturer’s
installation instructions.
2. Convert to Tempered or Filtered Water (Optional)
Remove the hot water supply hose from the valve body assembly
with a wrench.
Cap the hot water supply inlet on the valve body assembly with
a plug (provided). Wrench tighten the cap.
Turn the mixer valve on the valve body assembly to full cold.
O-Ring
Faucet
Bracket
Washer
Nut
Sink
Threaded
Stud
Sensor Cable
Flexible Hose
1056542-2-B 4 Kohler Co.