• Permanent independent smoke and carbon monoxide
sensors.
• Smoke alarm takes precedence when both smoke
and carbon monoxide are present.
• Alarm/Voice message warning system that alerts you of
the following conditions in the manner described
below, thus eliminating any confusion over which
alarm is sounding:
– FIRE: The alarm/voice pattern is three long alarm
beeps followed by the verbal warning message
“FIRE! FIRE!”. This pattern is repeated until the
smoke is eliminated. The red LED light will flash
while in alarm/voice mode.
– CARBON MONOXIDE: The alarm/voice pattern is
four short alarm beeps followed by the verbal
warning message “WARNING! CARBON
MONOXIDE!”. After four minutes the alarm/voice
pattern will sound once every minute until the
unit is reset, or the CO eliminated. The red LED
light will flash while in alarm/voice mode.
– LOW BATTERY: When the batteries are low and
need replacing the red LED light will flash and the
unit will “chirp” one time, followed by the warning
message “LOW BATTERY”. This cycle will occur once
every minute for the first hour. After the first hour
the red LED light will continue to flash every minute
accompanied by the “chirp” only sound. The voice
message “LOW BATTERY” will sound once every
fifteen minutes during the “chirp” only cycle.
This will continue for at least seven days.
• One “chirp” every 30 seconds is an indication that
the alarm is malfunctioning. If this occurs call the
Consumer Hotline at 1-800-880-6788.
Features
4