Kidde 2508-7201-07 Carbon Monoxide Alarm User Manual


 
General Maintenance
23
WARNING! Use only the batteries specified. Use of different
batteries may have a detrimental effect on the Smoke/CO alarm.
A good safety measure is to replace the battery at least once a
year, or at the same time yo change your clocks for daylight
saving time.
Alarm Replacement
Seven years after initial power-up, this unit will “chirp” twice
every 30 seconds to indicate that it is time to replace the alarm.
A label has been provided on the side of the alarm that has
“Replace by” printed on it. Write the replace by date on the
label. The date written on the label should be after seven (7)
years of cumulative power.
REPLACE IMMEDIATELY! IT WILL NOT DETECT CO IN THIS
CONDITION.
To keep your Smoke/CO Alarm in good working order, please
follow these simple steps:
Verify the unit's alarm and LED lights operation by pushing the
test/reset button once a week.
Remove the unit from mounting bracket and vacuum the
alarm cover and vents with a soft brush attachment once a
month to remove dust and dirt. REINSTALL IMMEDIATELY
AFTER CLEANING AND THEN TEST USING THE TEST/RESET
BUTTON!
Never use detergents or other solvents to clean the unit.
Avoid spraying air fresheners, hair spray, or other aerosols near
the Smoke/CO Alarm.
Do not paint the unit. Paint will seal the vents and interfere with
the sensor’s ability to detect smoke and CO. Never attempt to
disassemble the unit or clean inside. This action will void your
warranty.
Move the Smoke/CO Alarm and place in another location prior to
performing any of the following:
Staining or stripping wood floors or furniture
Painting
Wall papering
Using adhesives
2508-7201-07(810-1512N):_ 2011.5.3 9:05 AM Page 25