Kidde 2508-7201-07 Carbon Monoxide Alarm User Manual


 
Alarm Removal and Battery Replacement
22
CAUTION: YOUR SMOKE/CO ALARM IS SEALED AND THE
COVER IS NOT REMOVABLE!
To replace the battery you must first remove the alarm from the
mounting bracket by following the ALARM REMOVAL
instructions at the beginning of this section. After the alarm has
been removed, you can open the battery door and replace the
battery.
Battery installation instructions are provided on the inside of the
battery door.
When installing the battery, press the battery reminder finger
down into the battery compartment and install the battery (see
figure 6).
CAUTION! IF THE BATTERY REMINDER FINGER IS NOT HELD
DOWN IN THE BATTERY COMPARTMENT BY THE BATTERY,
THE BATTERY DOOR WILL NOT CLOSE, THE AC QUICK
CONNECTOR WILL NOT ATTACH TO THE ALARM, AND THE
ALARM WILL NOT ATTACH TO THE MOUNTING BRACKET.
After installing or changing the battery, reinstall your alarm. Test
your alarm by using the test/reset button and check that the
green LED is on.
Replace batteries with one of the following approved brands:
Duracell MN1604, MX1604, Energizer 522, Gold Peak 1604A,
Ultralife U9VL-J. These batteries can be purchased at your local
retailer.
FIGURE 6 Battery Replacement
Battery
finger
2508-7201-07(810-1512N):_ 2011.5.3 9:05 AM Page 24