Filter
Top Products
17
Install Covers and Restart Water Heater
FIG. 23
INSTALL COVERS
After installing your water softener, replace the covers.
Angle the covers so the main cover clips onto the back
first, then bring down in front and clip on the two (2) tabs
inside the rim of the salt hole and lower the salt cover
closed. See Fig. 23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater
and light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Salt Hole
Cover
Cover
(Main)
Questions? Call The Kenmore Water Line 1-800-426-9345
Program The Timer
Display
DOWN Button
Model 38426
Model 39426
UP Button
REGENERATION Button
SELECT Buttons
FIG. 24
Model: H46
Version: G1.1
Thank You
For Choosing Kenmore
...For Quality Water
Present Time:
12:00
PM
CHANGE SELECT
b d
Model: H47
Version: G1.1
Thank You
For Choosing Kenmore
...For Quality Water
Present Time:
12:00
PM
CHANGE SELECT
b d
FIG. 25
PROGRAM THE TIMER
1. When the transformer is plugged in, the model code H46
or H47, and a test number (example: G1.1) show in the
face plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
NOTE: If “- - - -” shows in the display, press the UP or
DOWN button until H46, for Model 38426, or H47 for
Model 39426, shows in the display. Then, press the
SELECT button to set, and change to the flashing
PRESENT TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than this code
shows, refer to the Troubleshooting Section.
SOUND “BEEPER”: A “beeper” sounds while pressing
buttons for timer setup. One beep signals a change in the
face plate display. Repeated beeps mean the timer will not
accept a change from the button you have pressed, telling
you to use another button. For example, while setting the
hardness the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest hard-
ness setting using the UP button.time rapidly.