Kenmore C675-25010 Dehumidifier User Manual


 
FEATURES AND THEIR
FUNCTION
YOUR CONTROL PANEL WILL LOOK
SIMILAR TO THIS:
Humidistat
(Not on model 25015)
The Humidistat turns the unit on or off
automatically. Set control knob initially on
maximum setting until the desired humidity
level is achieved, then slowly turn the control
counterclockwise until the unit shuts off. The
Humidistat will now automatically maintain this
selected level of humidity.
AUTOMATIC
HUMIDISTAT
AUTOMATIC
HUMIDISTAT
PAN-FULL
SIGNAL LIGHT
PAN-FULL
SIGNAL LIGHT
TWO SPEED
FAN CONTROL
Fan
Some models are equipped with a fan speed
control. This allows adjustment of the air flow
through dehumidifier.
For maximum dehumidification keep the control
at the maximum setting.
Automatic Overflow Protection
The automatic shut-off switch turns off the
dehumidifier when the moisture pan is filled to
its preset level. To continue dehumidification,
simply remove water pan, empty and slide it
back in place observing the following caution.
Caution: Float must be freely suspended. If the
pan traps the float, it is possible that the
dehumidifier will not operate. It is also possible
that the dehumidifier will operate but water will
overflow on to the floor when the pan fills.
Always check to make sure the float is freely
suspended in the pan.
Pan-Full Signal Light (some models)
The signal light warns when moisture pan is
full. Be sure to replace pan properly so unit will
run. If the light remains on, check for trapped
float.
Hook-up For Direct To Drain Disposal
To eliminate the need for regular periodic emp-
tying of the moisture pan, your dehumidifier
may be hooked directly to a drain using a
standard garden hose with metal coupling
attached to the fitting located on the drip tray
above the moisture pan. Ensure hose attached
to the fitting located on the drip tray above the
moisture pan. Ensure hose slopes uniformly
downward to the drain.
TROUBLESHOOTING
If dehumidifier stops running: Refer to the
performance chart on Page 6 for operating
limits.
1. See if power cord is plugged in properly and
unit is turned on. This is confirmed by green
power-on light (on models so equipped).
4