Filter
Top Products
PARTS OF THE SYSTEM MATERIALS AND TOOLS NEEDED
filter system assembly including mounting brack-
et and screws
water supply fitting
_" filtered water faucet for sink or countertop mount-
ing
3/8" tubing to make all needed connections
• plumbers putty
• slotted and Phillips screwdrivers
• pliers and adjustable jaw wrench
• tubing cutter
• sandpaper or emery cloth
• electric driU and 3 / 4" d_l bit if mounting hole is
needed for the faucet, see page 6
CAUTION: To avoid damaging the sink, consult a
qualified plumber or installer for dialing procedures
in porcelain or stainless steel.
FIG. 1
TYPICAL UNDERSINK INSTALLATION
filtered water
faucet
supply fitting
shutoff valve
Note: To change the fil-
ter cartridge, you must
turn offthe water and re-
tease pressure by open-
ing the faucet. A nearby
shutoff valve is conve*
nient. Most sinks al-
ready have shutoff
valves on the supply
pipes.
\
\
\
WATER
IN
$
mounting
screw (2)
Filter II
Filter I
Note: Besure toallowa minimumspaceof 1-1/2" under
the system for removing the sump& to change the
cartridges.
4