Kenmore 625.3485400 Water System User Manual


 
WATER SOFTENER START-UP
SECTION 1
6
1C. PROGRAM THE TIMER
FIG. 1
When the transformer is plugged in, the model
code AR31, and a test number (example: A1.0)
show in the face plate display for 4 seconds.
Then, 12:00 AM and PRESENT TIME begin to
flash.
NOTE:
If AR-- shows in the display, press the UP or
DOWN button until AR31 shows. Then, press
the #1 SELECT button to set, and change to the
flashing PRESENT TIME display.
Tocheck the model code,unplug the transformer
at the wall outlet and plug in again. if other than
AR31 shows, see page 18 to reset.
SOUND BEEPER: A beeper sounds while
pressing buttons for timer set-up. One beep
signals a change in the face plate display.
Repeated beeps mean the timer will not accept a
change from the button you have pressed, telling
you to use another button. For example, while
setting the hardness (step 2), the beeper sounds
repeatedly when the display reaches 1 using the
DOWN button, or the highest hardness setting
using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words¼PRESENT TIME do not show
in the display, press the #1 SELECT button
(FIG. 1) until they do, or see the notes above.
n Press the UP/DOWN buttons to set the
present time. Press UP to move the display
ahead; press DOWN to movethe time backward.
If the present time is between
noon and midnight,be surePM
shows.
If the present time is between
midnight and noon, be sure
AM shows.
NOTE:
Each press of the UP/DOWN
buttons changes the time by 1
minute. Holding the buttons in
changes the time 32 minutes
each second.