Filter
Top Products
OTHER THINGS TO KNOW
SECTION 4
19
4A. HOW TO “FINE-TUNE” YOUR SOFTENER
c. Press the RECHARGE DAY button and
SUnday begins to flash.
–– If you want regenerations on Sunday (from
regeneration table), press the SET/CLEAR button
to display ON.
–– If you do not want Sunday regenerations, press
the SET/CLEAR button
to display OFF.
d
. Press the RECHARGE DAY button again to
display a flashing MOnday and ON (factory set
recharge). As you did in step c, use the SET/
CLEAR button
to change the display from
ON to OFF, or from OFF to ON.
e
. Press RECHARGE DAY button to display a
flashing TUesday, WEdnesday, etc., each time
using the SET/CLEAR button
to display eiĆ
ther ON or OFF as needed.
After recharge is either set or cancelled for SAtĆ
urday, press the PRESENT TIME AND DAY
button
once again to return the present
time and day display.
2. SET THE FILL CYCLE MINUTES
a. Press and hold the RECHARGE TIME button
until FILL shows in the display, then release
button
. After a few seconds, the fill cycle
minutes (factory setting…16) will flash.
b
. Press the SET/CLEAR button to set the minĆ
utes of fill cycle needed, as shown in the reĆ
generation table.
NOTE:
You may get hard water between regenerations if
you set the timer for fewer fill minutes than the
Regeneration Table shows you to set. A higher
setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move the
display ahead 1 minute at a time. Or, hold the
SET/CLEAR button to move the display ahead 2
minutes each second. THE DISPLAY BEGINS
OVER AT 0 AFTER PASSING 59.
c
. Press PRESENT TIME AND DAY button to
return the present time and day display.
TO SET the PRESENT TIME OF DAY, and DAY OF
WEEK, see page 6.
If you need help to program the timer, call toll free,
number 1-800- 426-9345.