Filter
Top Products
FEATURES
6 5
32714
18 179 8
I3 16
FIG. 24
1 Cabinet
2oVertical Air
Direction Louvers
3, Horizontal Air
Direction Louvers
4. inlet Grille
5o Air Filter
6. Front Grille
7 Control Board
8 Power Cord
9, Evaporator Coil
10oCondenser
t 1 Compressor
12 Base pan
- 13 Brace
14 Upper Guide
15.,Curtain
16 Remote Control
17 Air Purifying Filter
18 Case, Filter
USING THE AIR CONDgTIONER
r!'_i_-[_ TO reduce the risk of fire, electric
shock, or injury to persons, read the important
SAFETY instructions section before operating this
appliance
To begin operating the air conditioner after
installation, follow these steps:
1. Plug in the air conditioner. (To prevent electrical
hazards, do not use an extension cord or an
adapter plug..)
2. Set the exhaust vent to the CLOSE position..
3. Set the TEMP Control to the coolest setting.,
4 Set the MODE control at the highest COOL level
5. Adjust the louvers for comfortable air flow.
6 Once the room has cooled, adjust the TEMP and
Mode Control to the setting you find most
comfortable
NOTE : If the air conditioner is turned off, wait 3
minutes before restarting.. This allows pressure
inside the compressor to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation
if you move the TEMP Control to a warmer, then
immediately back to a cooler setting, the unit will
shut off. Wait 3 minutes before restarting.
VENT CONTROL
The Vent Control allows the air conditioner to
either recirculate inside air (CLOSE) or exhaust
air to the outside (OPEN) (FIG 25)
- The CLOSE position is used when maximum
cooling is desired It may also be used for air
recircuration without cooling when the air
conditioner is set in the FAN positiOn,r
"The OPEN position removes stale air from the
room and exhausts it to the outside Fresh air is
drawn into the room through your home's
normal air passages,,
,,The OPEN or CLOSE position can be used with
any fan selection,
PULL OPEN / PUSH CLOSE
FgG. 25
-10-