Kenmore 408.72012 Air Conditioner User Manual


 
INSTALLATION
LOCATION OF THE PORTABLE AIR CONDITIONER
WINDOW KIT INSTALLATION
The Window Kit (included) contains three sliding pieces, and can be adjusted
to t most standard vertical and horizontal windows (see Figs. 1 & 1a). For
very wide windows, use all three pieces. For very narrow windows, you may
have to cut down the end of the piece with the hose attachment hole. Do not
cut into the hole.
EXHAUST HOSE CONNECTION
The exhaust hose must be attached to the appropriate side of the unit given
the desired application, either cooling or heating (see Operating Instructions).
When changing applications, switch the adjustable air vent and exhaust hose
holder (hose can remain attached) to the opposite sides of the unit.
SAFETY PLUG
This product is equipped with an LCDI (Leakage Current Detection and
Interruption) safety plug. If power shuts o, unplug from the electrical outlet
and make sure the cord is undamaged. If the cord is damaged, return the unit
to a Sears Service Center for repair before using it again.
TO TEST THE SAFETY PLUG
1. Connect the power plug to an electrical outlet.
2. The power plug has two buttons located on the top. One button is marked
“TEST” and the other is marked “RESET”. Press the “TEST” button; you will
hear a click as the “RESET” button pops out.
3. Press the “RESET” button; you will hear a click as the button engages.
4. The power supply cord is now energized and supplying electricity to the
air conditioner (it is indicated by a light on the plug head).
Under no circumstances should this device be used to turn the unit on
or o.
The “RESET” button must always be pushed in (engaged) for correct
operation.
The power supply cord must be replaced if it fails to reset when the
“TEST” button is pushed in.
CONTROL PANEL
10 11
1. Select a location near a window and
electrical outlet.
2. Position the unit in a at, spacious location
with a minimum of one foot of clearance
(30 cm) between the air outlets and any
wall or pieces of furniture.
3. If placing the unit outside of the room to be
cooled, position it on a at solid surface,
preferably in a space with overhead
shielding from rain and the direct rays
of the sun. Do not operate the unit in
extremely moist areas such as a sauna.
1. POWER
Press this button to switch the unit on or o.
2. MODE
Press this button to select between Cooling ( ),
Heating ( ) or Dehumidifying ( ) mode.
NOTE: To change display between °F
and °C, press the MODE button for 10
seconds with the power o and unit
plugged in (Standby Mode). You will
hear a beep when the change occurs.
3. TEMP+
Pressing this button in cooling
mode increases the desired room
temperature setting by 1°F (1°C) up to
a maximum setting of 86°F (30°C).
Pressing this button in heating
mode increases the desired room
temperature setting by 1°F (1°C) up to
a maximum setting of 77°F (25°C).
Fig. 1
Window kit
Min: 19 in.
(48 cm)
Max: 50 in.
(127 cm)
Vertical Window Horizontal Window
Window kit
Min: 19 in.
(48 cm)
Max: 50 in.
(127 cm)
Fig. 1a
(
2
)
(
6
)
(
3
)
(
5
)
(
7
)
(
1
) (
4
)
(
8
)