Open as PDF
Install 3-Valve Bypass
INSTALLING 3 VALVE BYPASS AND PIPES
Complete the following steps to install the three (3)
• Cut the house main water pipe where you will con-
nect the softener.
• Loosely put together pipe, fittings, and the three
• Place valve(s) within easy reach.
When all pipe, fittings and valves make a good fit
together, tighten all threaded joints (use pipe dope
on outside threads), or solder all sweat joints.
3 VALVE BYPASS
Questions? Call The Kenmore Water Line 1-800-426-9345
Install Plastic Bypass Valve
BYPASS VALVE TURNED DOWNWARD
Turn bypass valve upside
down to connect to floor
INSTALLING HOLDING CLIPS
Cross Section of Valve
Inlet or Outlet
Bypass Valve or
Clip Snaps into Place
Between Larger Diameter Rings
Before installing the bypass valve, or
copper tube, be sure the turbine and
support are firmly in place in the
valve outlet port.