Filter
Top Products
?
Installation Instructions
Removing the Old Water Heater
Turn "OFF" the gas supply to the water heater.
AWARNING o
If the main gas line shutoff serving all _ appliances is
used, also shut "OFF" the gas at each appliance. Leave all
gas appliances shut "OFF" until the water heater installa-
t on scomp ete.
Turn water to water
"OFF" the
the
heater. Some installations require that
the water be turned off to the entire
house.
Check again to make sure the gas supply
is "OFF" to the water heater. Then dis-
connect the gas supply connection from
the gas control valve.
('_Disconnect the vent pipe from the draft hood where
they connect to the water heater. In most installations
the vent pipe can be lifted offafter any screw or other
attached devices are removed. Dispose of the draft
hood. The new water heater has the draft hood which
must be used for proper operation.
®
® ®
Q Attach a to water heater drain
hose the
valve and put the other end in a floor
drain or outdoors. Open the water heater
drain valve. Open a nearby hot water
faucet which will relieve pressure in the
water heater and speed draining.
a.
If you have copper piping to the water
heater, the two copper water pipes can
be cut with a hacksaw approximately4"
away from where they connect to the
water heater. This will avoid cutting off
the pipes too short. Additional cuts can
be made later if necessary. Disconnect
the temperature-pressure relief valve
drain line. When the water heater is
drained, disconnect the hose from the
drain valve. Close the drain valve. The
water heater is now completely discon-
nected andready to be removed.
Q b. you galvanized pipe to water
If
have the
heater, loosen the two galvanized pipes
with a pipe wrench at the union in each
line. Also disconnect the piping remain-
ing to the water heater. These pieces
should be saved since they may be need-
ed when recofinecting the new water
heater. Disconnect the temperature-pres-
sure relief valve drain line. When the
water heater is drained, disconnect the
hose from the drain valve. Close the
drain valve. The water heater is now
completely disconnected and ready to be
removed.
AWARNING ]
The water passingou_ve may be extremely]
hot. To avoidbeingscalded make sure all connectionsare|
tight and that the water flow is directed away from anyI
person, i J
A CAUTION J
Mineral buildup or sediment may have accumulated in the J
old water heater. This causes the water heater to be much
heavier than normal and this residue, if spilled out, could
cause staining.