Filter
Top Products
_!1 I III -
Prepare the bobbin
Load Thread on the Bobbin (Model 14501, 14502, 14571, 14572 only)
®
(Model 14571 )
(Model 14501 )
®
........ t.
®
1. Disengage the clutch by pulling the i_and
wheel out (Model 14571) or turning the
clutch knob toward you (Model 14501).
. a.
b.
. a.
Put a spool of thread on the spool pin.
Place a suitable size spool cap over the
spool.
c. Draw the thread from the spool through
the thread guide.
Wind the thread around the bobbin
several times in the direction of the
arrow.
b. Place the bobbin onto the bobbin
winder shaft.
4. a. Push the bobbin winder latch against
the bobbin until it clicks.
b. Start the machine by pressing down on
the foot control.
NOTE: The bobbin will automatically stop
turning when it is filled.
5. Remove the bobbin from the shaft and
trim the end of the thread.
6. Engage the clutch by pushing the hand
wheel back in toward the machine
(Model 14571) or turning the clutch knob
away from you (Model 14501).
10