Filter
Top Products
Checkmotorsafetyfilter frequentlyand
cleanwhendirty.
, 'WARNI'NG
Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed
to prevent motor failure and/or
electrical shock.
Always unplug power cord from
electrical outlet before performing
any sewice on vacuum.
TO REMOVE BAG
Press the release
button located on
the top of the bag
cover.
Release
Button
Bag
Cover
Dust
\
Bag
Grasp the
dust bag
collar and
pull gently,
carefully
removing
the dust
bag.
Pull the bag
cover forward.
Remove and fay
aside.
Safety
Seal Tab
If the motor safety filter, located in the bot-
tom of the dust bag cavity is dirty, remove it
by pulling forward out from under the ribs°
Wash the foam filter in warm soapy water,
rinse and dry thoroughly by squeezing the
filter in your hand and letting it air dry_
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace the foam filter by sliding it back into
place under the ribs in the dust bag cavity,
TO REP LAC E BAG
Dust Bag
Safety
Seal Tab
Fold the
safety seal
tab on the
new bag
away from the
opening that
fits on the dirt
tube,
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet
fresheners, face powder, fine dust,
plaster, soot, etc. can clog the bag
and cause it to burst before it is
full. Change bag more often when
vacuuming these materials.
14