Kenmore 116.31732 Vacuum Cleaner User Manual


 
The attached
hose swivels to
make cleaning
easier in every swivel-
direction.
Remove the
hose from Ihe
hose clip by
pulling straight
out.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
- Crevice
Tool
Remove the
telescoping
Telescoping wand from
Wand
its storage
position.
R_nove the crevice tool from its storage
position in the wand. Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length.Turn the
locking ring to the LOCK position. Attach
the extension wand onto the open end of
the bose.
Lower_"_ _ Suction
Wand ___Control Slide
\ _\Locki.gRt.g I _
Upper
Wand
When using the dusting brush or the combi-
nation brush, theymay be attached directly
to the wand or placed on the end of the
crevice tool.
Align the tabs on the extension wand with
the "J" slots in the hose. Push the wand into
the hose and twist to the right to lock.
To achieve maximum
reach with the attach-
ments, add the crevice
tool to tile end of
Ihe wand by Hose
inserting
and twist- Suction
Control
ing slightly. Slide
Wand,
Tool
TO OPERATE SUCTION
CONTROL SLIDE
Telescoping Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twistthe suction control slkJe
to the open position. This lever is located on
the telescoping wand, close to the hose.
This will
reduce
suction for
ease of
cleaning.
Suction
Control
Slide
NOTE: Return suction control slide to the
closed position fornormal cleaning.
! CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching.Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over.
Make sure the carpet/bare floor
selector is in the bare floor position.
Damage to the floor surface may
occur if the carpet setting is used.