Kenmore 116.25914 Vacuum Cleaner User Manual


 
CANISTER
1. Open the canister hood.
2. Check to see that the dust bag is proper-
ly installed. See BAG CHANGING for
instructions.
3. Check to see that the motor safety filter is
properly installed. See MOTOR SAFETY
FILTER CHANGING for instructions.
HOOD AND TOOL
STORAGE COVER
It is normal for the canister hood and tool
storage cover to come off when opened fur-
ther than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to reinstall.
CAUTION
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canister hood and/or tool storage cover.
HOSE
t. Line up the hose
latch tab and notch
in canister hood
and insert hose
into canister until it
snaps in place.
To remove: Lift
hose latch tab
upward and pull up
on hose.
Lock
Hose
Latch
Tab
Noah
m
2. Insert han-
dle into wand
until lock but-
ton snaps in
place. Be
sure hose is
not twisted.
To remove:
Handle Press handle
Quick quick release
Release_ button and
pull up on
handle.
To store: Disconnect hose from wand and
canister to prevent stress on hose during
storage. Store hose in a loosely coiled
position so the hose covedng is not
stressed.
This canister is equipped with an on-board
storage area for a Power-Mate Jr. ®attach-
ment.
To Install:
Open the Power-Mate Jr.e storage cover.
Insert the Power-Mate Jr.e, press down into
place, and close the lid securely.
To Remove:
Open the storage cover. Remove Power-
Mate Jr. ° from the storage area and use as
needed (see A'I-rACHMENTS and A'I-rACH-
MENT USE TABLE).
Power-Mate Jr.a
Storage Cover
7