Filter
Top Products
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is chart eg__d
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clea__l__n_A_itator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
every 2 months
IMPORTANT
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
Power-Mate ® agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps,
AGITATOR ASSEMBLY
Belt Pulley q
"-..Tj,-r"_ / Cap
Brush Unit
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt pulley
r
Agitator End Cap
NOTE: See PARTS AND FEATURES for
Belt number.
2. Place agitator
assembly back into
Power-Mate e
3. Line up ./__J_"!"_///'_"
front of
cover and
baseoRest _ _(_I_ !)!_
cover on
front edge "%Z'Z.Z_.z-z_ _!!!_;
of base as ! er !i il_;!_';--'__,,_-,,_
shown. ': ::-=";_"
Co Base ;_?!_
4, NOTE: On dirt sensor models be sure _t'_;:::_.::;
that the board is upright and the wires are
tucked back in place.
]
5. Rotata cover
back. Press
cover firmly until "
side and rear ,, ,! - "_
tabs snap into .... -_ ._
place,
Make sure there Side Rear
Latch Latches
is no gap
between the cover and base
6. Turn Power-Mate®upside down and
replace two (2) cover screws,
19